See Fig. 1 -2 and 4-6. On 1987-96 Pickup and 1987-93 Ram-50, reset switch is on lower right corner of instrument cluster, behind cluster face trim. See Fig. 3 . Slide switch to opposite side to reset indicator light. Remove warning light bulb after 150,000 mile service on Colt Vista and Colt Wagon. Remove light bulb after 100,000 mile service

Push the START button two times. Then push the back button to clear any message and to get to the main screen. Next, you’ll use the directional pad to move to the right into the ⚙️. After that, you will go down and find the VEHICLE SETTINGS. From there select the SCHEDULE MAINTENANCE or OIL MAINTENANCE.

Here’s a step-by-step guide on how to do it: First find the maintenance light on your dash. It’s a small icon that looks like a car with a wrench in the middle. Once you’ve found it press and hold the Trip button (the one with the odometer reading) for about 5 seconds. The maintenance light should now be reset and should no longer be The computer system tracks the engine miles from the time it was reset, and the light will trigger after a certain amount of miles add up. The owner has the ability to set the mileage intervals between the triggering of each maintenance light, depending on how the owner uses the vehicle, and under what conditions he or she drives.
3. Turn the key to OFF. 4. Place your finger back on the odometer button, press and hold. Then while still holding the button, turn the key back to "On" (not START). 5. Hold the odometer button in until the MAINT REQD light goes outshould take about 8-10 seconds.
Alternatively, if your vehicle has a keyless start system, the steps to reset the maintenance light are as follows: Press and hold down the odometer button. Wait until 000000 Miles appears on display. Turn off the engine using the power button. The light should go off. If the light does not go off, repeat the steps.

Once you get there, you’ll press it and hold it for three seconds to get on the menu. Go to the MAINTENANCE. From there you can you’ll turn that knob clockwise to scroll down to the MAINTENANCE and press it to select. Select SERVICE. In this menu, we’ll select the SERVICE. Set the interval or RESET.

To reset the maintenance light, you will need to open the hood of the Camry and locate the fuse box. Inside the fuse box, you will find a reset fuse labeled Maint. Pull this fuse out for a few seconds before reinserting it. Once the fuse has been reset, close the hood and start the Camry.
Press the button until you see the “SETTING” screen. The button is located on the instrument panel. Scroll to the MAINTENANCE menu by using the ⚈ button. Press the button to enter the menu. Select TIRE. The reset mode will open up. You can set a reminder at a specific interval or RESET the current one in this menu. To reset the Toyota Tundra’s maintenance light, turn off your car and press the reset button. The buttons on this page are usually labeled ‘Odour’ or ‘Trips.’. Turn on and off your car by pressing and holding the button for about 20 seconds. Reset the maintenance light! Your maintenance light should have reset. This video shows u how to reset the "Maint Req'd" light after doing an oil change on a 2010 Toyota Corolla.
Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code (s) will blink. Press the select/reset knob for another 5 seconds. The maintenance item code (s) will disappear, and the engine oil life will reset to ‘‘100.’’. Turn the ignition off and then start the engine to verify the indicator has
LEXUS LS430 HOW TO RESET MAINTENANCE REQUIRED LIGHTIf This Helped You Reset Your Required Maintenance Light And You Would Like To Donate To Me Anything Helps
Next, go up or down whatever you want to reach to the ⚙️ SETTINGS. Then you go to the right and keep going until you get to the VEHICLE SETTINGS. Press the OK button to get in. After that, you go down and select the OIL MAINTENANCE or SCHEDULE MAINTENANCE. Finally, select YES to perform maintenance data reset.
zrUsx.
  • ep9layq7wi.pages.dev/373
  • ep9layq7wi.pages.dev/426
  • ep9layq7wi.pages.dev/220
  • ep9layq7wi.pages.dev/396
  • ep9layq7wi.pages.dev/481
  • ep9layq7wi.pages.dev/33
  • ep9layq7wi.pages.dev/273
  • ep9layq7wi.pages.dev/424

    • how do you reset the maintenance light