The cylinder placing is ( as your are looking at the front of the truck) passenger side front to back 1-2-3-4 driving side front to back 5-6-7-8. If you never seen a coil buy one so you know what you are looking for. The coil is held in by a 7mm bolt. Take the bolt out and replace the coil. Problem Solved.
Sometimes, it's just about the ECU. But you should check if these signs come together: the Transmission Fault, Service Now message appears on the dash; it doesn't get cleaned off when you restart the engine; the transmission starts working badly, it punches the vehicle when shifting between the 1st and the 2nd gears; the mileage of the Focus is
Note: Simply reading the codes can do no harm, and does not change anything. Just do not reset the codes (and you would have to ask the scanner to do this) if you are going to take the car to a garage. Peter. Just checked on forscan for the errors and there is a few there which im guessing is the reason why the warning message comes up.
Drivers may find it difficult or impossible to start the engine because of the resulting engine performance problems. If they persist in operating the vehicle, they may lose power while on the road. Also, ignoring the camshaft position sensor issue for too long can even damage the engine, leading to a much longer and more expensive repair job.
6321 posts · Joined 2009. #9 · Jan 14, 2016. Reduced acceleration is usually a sign of low voltage, but if you have replaced the battery that should not be an issue unless the alternator is not charging properly. Might be worth checking the earthing points are clean and tight.
WW3nD.
  • ep9layq7wi.pages.dev/199
  • ep9layq7wi.pages.dev/139
  • ep9layq7wi.pages.dev/148
  • ep9layq7wi.pages.dev/132
  • ep9layq7wi.pages.dev/338
  • ep9layq7wi.pages.dev/171
  • ep9layq7wi.pages.dev/254
  • ep9layq7wi.pages.dev/79

    • how do you fix a ford focus engine malfunction